This is a 3D printed 2-axis GoPro gimbal. It is made to support the Gopro while mounted inside of the polycarbonate enclosure. The mounts are designed to work with the Xaircraft DIY frames. The gimbal frame can be made from any half inch dowel or 12mm tube. I designed it to be compatible with the following: […]
Monthly Archives: February 2012
In order to obtain more stable and responsive flight with my flight controller I decided to flash my four 30A BlueSeries speed controllers with SimonK’s custom firmware. The hardware of the ESCs I have received has been updated and no longer has the same component layout as the old 30A BlueSeries. The board now only contains N-Fets instead […]
In order to obtain more stable and responsive flight with my hexacopter I decided to flash the six 25A redbrick speed controllers with SimonK’s custom firmware. For more information see the RCGroups thread. First I cut the heat shrink from each speed controller and removed the top heat sink so that the programming pads were accessible. Using standard […]
This is a tutorial of how I flashed and setup my transmitter for use with MultiWii and Ardupilot, more information can be found here. You will need to be sure that you have access to an ISP programmer in order to flash the firmware of the transmitter. I use the Sparkfun Pocket AVR Programmer but […]
This is the bill of materials for my Xaircraft Carbon Fiber X4 drone. I plan to use higher performance components than my previous builds with the addition of a budget autopilot system. The above model for the Xaircraft X4 frame with Avroto motors can be found here. [Qty. 1] Xaircraft X4 Carbon Fiber DIY Frame […]
- 1
- 2