The V3 LCD radio mount turns the Turnigy 9X, DX5, DX6, DX7 and DX8 into a portable FPV ground station compatible with a wide range of LCD monitors. The parts of the mount are 3D printed with plastic. The mount loops around the antenna and conveniently clips to the rear handle of the radio, making it strong yet very easy to remove. The monitor can be secured to the mount by multiple methods; using the supplied rear channel piece to slide the monitor onto the mount, securing the monitor with a lower bolt, rear bolt, or applying Velcro or double sided tape to the back of the monitor panel. To the rear of the supports are a set of slots for securing wiring with cable ties or using Velcro straps to secure video receivers or batteries.
Use Thick CA glue with CA accelerator for assembly.
Product VideoAssembly Required
| Weight | 3 oz |
|---|---|
| Required Tools & Supplies | Super Glue (CA Glue), Hobby Knife |
| Compatible Monitors | Boscam RC701 Diversity Monitor, Haier HLT71 HD LCD Monitor, Fieldview 777 TFT Monitor, Generic Car Monitor |
3 reviews for V3 LCD Radio Mount
Add a review
You must be logged in to post a review.
Related products
Out of stock
Multicopter Frames
$1.00
Out of stock
Multicopter Frames
$39.00 – $64.00
Out of stock
Multicopter Frames
$5.00 – $7.00
Out of stock
Multicopter Frames
$19.00 – $27.00
Out of stock
Multicopter Frames
$5.00 – $7.00
Out of stock
Multicopter Frames
$19.00 – $36.00
Out of stock
Multicopter Frames
$3.00 – $5.00
Michael Zietlow –
Great fit! love the simplicity of the design. Like the reviewer said, take you time gluing it together. This 3D printed stuff wile rigid cool has some flex when hot. Be careful in High Heat areas and dont leave it in your car to bake.
Doug M –
I really like this “UNIQUE” design mount for it’s clean lines and it’s accompanying features for attaching different sized video RX devices and batteries. These features make it awesome for any portable FPV ground station setup. This snap-on mount made it easy for me to install on my Turnigy 9X. I applied CA glue in a few stages to various locations on the frame *TAKE YOUR TIME* let if dry! There are two locations to attached the LCD monitor – I used both! I also applied a few small pieces of duck tape to the rear handle of my 9X to keep the frame clips from sliding on the smooth surface of the handle. If you think all ground station monitor mounts are created equal, think again. This V3 LCD Mount far surpasses its competition with included features and intuitive design functionality. I would highly recommend this “UNIQUE” LCD Monitor mount to anyone interested in building a portable FPV ground station!
Jorge C. –
Great product. It’s well made and holds the recommended LCD in place extremely well. I assembled it with just hot glue and the way the parts fit together, it works perfectly. It was shipped in just a couple days and i couldnt be more happy with this mount. Thanks a lot and I hope to do business with you in the future some time.